DIY 1000 watt wind turbine

Step 2: Build the coil disk DIY-1000-watt-wind-turbine-7



DIY-1000-watt-wind-turbine-10 watt-wind-turbine-1


We wound the nine individual coils, soldered them in a 3 phase wye configuration, and encased them in resin. We used 35 turns of 2 parallel strands of 14 gauge enameled (magnet) wire for 12 volts. Use 70 turns of single strand for 24 volts. # 3 phase diagram shown here shows 3 stator coils. each of those coils is actually 3 coils in series. coils 1,4, and 7 are series together, 2,5, and 8 are series together, and 3,6, and 9 are series together.

more details, see the following page 15 for the series star, 1-y diagram.


Share This Post

Leave a Reply

Submit Comment

© . All rights reserved.